Here is the KAZZ Engineering M50 manifold to M52 throttle body adapters!
This product has been offered since the beginning of KAZZ Engineering and has proven to perform perfectly amongst our fellow enthusiasts for years. Say it with me: “No more vacuum leaks.”
About the material…
This 2mm aluminium product is profile cut right here in Brisbane, Australia.
What’s the point…
This product allows you to properly seal a M52 throttle body to a M50 manifold.
The M50 manifold conversion is a common power upgrade which allows more air into your restricted M52 motor.
Note:
1) The M50 motors have an o-ring on the manifold and a flat surface on throttle body
2) The M52 motors have an o-ring on the throttle body and a flat surface on the manifold.
This results in rubber o-rings on each side when using a M52 throttle body on a M50 manifold. ***Rubber on rubber is not a good seal***
You’re left with three options.
1) Enjoy vacuum leaks between the poor seal.
2) Use M50 throttle body (sometimes hard to acquire and also smaller bore than M52 throttle body).
3) Use your original, superior M52 throttle body with one of these adapters to ensure a trusty seal between o-rings.
The inner bore diameter for this part is 68mm which will also be suitable for most BBTB’s.
Install tips…
1) We strongly recommend all products are installed by a qualified mechanic
2) Watch Mike Lake install it here: https://youtu.be/YgoDS3c3frw?t=900
Reviews
There are no reviews yet.