So you need replacement Inner Tie Rods?!
KAZZ Engineering is stocking new rack ends for your convenience. All sold in pairs.
Note:
The rack ends available within this listing are compatible with E36, E46 and E9x outer tie rods. However, it is important to acknowledge that each of these inner tie rods vary in length and it is important you order the correct part for your setup. If you have a standard E36 for example, order the standard E36 inner tie rods.
What’s on offer?
In this listing you can find the following items available:
– E36 inner tie rod pair
– E46 inner tie rod pair (longer than E36)
– E90 inner tie rod pair (longer than E46)
-E36 outer tie rod pair — fits E30 and E36 hubs only!
Why do I need these?
There are many reason why you may be shopping for new inner tie rods. The part wear out over time – especially if the car is used for racing, drifitng, or rally! It is also common for enthusiast to change their inner tie rods to support other modifications.
A prime example of this is where you must use the E46 inner tie rods (which feature venting channels along the male thread) with a purple tag steering rack – a quick ratio replacement often retrofitted into E30 or E36 vehichles.
Another example of this is where extended control arms are installed. In order to have a neautral toe alignment it is important to also install extended tie rods to compensate for the wider track width you may gain from extended control arms. It is apparent that E46 inners are approximately an inch longer than E36 inners, and E90 inners are an additional inch longer again – approximately. We recommend anyone with our KAZZENG extended control arms to use E90 inners in their E30/E36/E46 cars.
It’s always handy to have spares at the track as this part is often the weak link in your steering system.
Reviews
There are no reviews yet.